These pieces of card cloth are designed for recovering our own Wingham Hand Carders, should the originals become worn or damaged. The pieces can also be used to re-fit other brands of carder, but the sizing will be down to you to work out.
Stainless steel wire for superior carding and long life.
Specification
Total length 195mm, width 110mm
Side margin of rubber 8mm
Top margin 9mm
Bottom margin 12mm
If you are fitting to a wooden back that is smaller dimensions it is possible to remove the carder pins
through the back of the foundation as they are formed like staples. The rubber/cloth backing can then be trimmed back with a sharp craft knife
Card cloth should be pinned to the backing board, never glued as this prevents the flexibility of the wire.
.jpg)
.jpg)
.jpg)