We sell quite a lot of the drum card cloth to home builders of machines, not too difficult a task if you have the tools.
Specification
Produced in continous length.
Total width of backing 215mm (8 3/8 ") Wire width 180mm (7") Side margin of rubber 16mm.
Tin plated steel wire
Sold in sheets of any length. A normal drum carder would cost around £65 to re-cover. We will quote for any length required. The standard wire is set at 72 point per square inch. Fine wire is 108 point
Card cloth is normally fixed to the drum with staples or tacks along the edge only. A jointing strip of metal is used where the ends meet. This acts as a partition line when removing the batt of fibres.
To calculate the amount required multiply the drum diameter by 3.142 . We always add a little extra free of charge for the joint. |
72DCCLOTH
No further discounts on
drum card cloth
108DCCLOTH |
